Q04:Can
I use Notebook build in wireless LAN to connect to GL2422-RT?
Most
of the notebook build-in 11Mbps wireless LAN connects to Access
Point easily with its default settings. 11Mbps wireless notebook can
connect to GL2422-RT in 11Mbps speed.
Here is only an example to show how it connects.
IBM
Notebook ThinkPad R31 build-in wireless LAN setting:
Find the “PRISM Setting” from Windows Start -> Control Panel,
setting as follows:
1. General: IBM High Rate Wireless LAN Mini PCI combo Card.
2.
Setting:
Profile=
Default
Mode=Infrastructure
SSID=AP22M
Transfer
Rate=Fully Automatic
3.
Encryption:
WEP=128
bit
Manual
Key 1 (1)=12345678900000000000000000
Default
Key=1
4.
Link: Link Quality and Signal Strength will be displayed.
You
may click “rescan” button to re-scanning.
5.
Advanced setting:
Adhoc
demo mode=<none>
Authentication
Algorithm=<none>
Fragmentation
Threshold=<none>
Listen
Interval=<none>
Preamble
Mode=<none>
RTS
Threshold=<none>
Click
here to
see the sample configuration of notebook wireless LAN.
GL2422-RT
Setting
Setup
GL2422-RT with Web browser:
1.
Main: LAN & DHCP Server, setup according to your Ethernet LAN
configuration.
2. Main: WAN, setup according to your WAN connection with ISP
supplied information.
3. Wireless: Basic, set wireless enabled, set ESSID, and select a
clean radio channel.
4. Wireless: WEP, The WEP can be disabled for easy testing. If you
enable WEP,
you must use the same key for both GL2422-RT and
ThinkPad wireless WEP setting.
5. Wireless: Advanced, normally its default settings can be used.
6. Status: In the status page, you may check if the basic settings
correct.
Click
here to
see the sample configuration of GL2422-RT wireless LAN.
top
|